Every Netgear extender comes with a number of LED lights. They depict the status of the extender. Green means everything is good. Orange means your device is struggling with connectivity issues and red means everything is wrong with it. So, if the LED on your Netgear extender is blinking red, you have come to the right post.
Here, you will find some of the topmost troubleshooting hacks following which you will be able to get rid of the Netgear extender red light issue in a matter of minutes. But, before you get down to reading, know this article mainly talks about Netgear extender WN200RPT, however, the hacks given below can be implemented to all models. Now, you can read on.
[Resolved] Netgear Extender Red Light Issue
- Check the Power Supply
The wall outlet into which you have plugged your Netgear WN200RPT extender, have a look at it. Do you find out that it needs repair? If you do, then it is recommended that you do the needful. In case, doing so does not bear any fruit for you, then consider plugging your WN200RPT device into another power outlet. Just make sure that this is not damaged.
- Verify the Ethernet Connection
Sometimes, using a damaged Ethernet cable to connect your networking devices can also cause the Netgear WN200RPT extender red light issue. Therefore, step out of your house and bring a new cable home. Use it to connect the extender to the router. See to it that the connection you have just built is not loose.
By any chance, if this does not work for you, it is recommended that a wireless source is brought into play. But, in that case, the distance between your devices should not be too much. Or else, their signals will collide at any time.
- Avoid WiFi Interference
Bluetooth speakers, cordless phones, washing machines, refrigerators, microwave ovens, and baby monitors, do you know what are these? They are smart home appliances. They can interfere with the signals of your WN200RPT extender thereby completely ruining its performance. Thus, you are required to relocate your wireless range device.
Once done, check if the Netgear WN200RPT extender red light issue persists. If it does, then following the next troubleshooting hack won’t do you any harm.
- Restart the Extender
Another thing that can be done to troubleshoot the Netgear WN200RPT extender red light issue is giving the extender a little restart. In order to restart your device, you just needed to turn it off for some time, and then, turn it back on.
In case, this hack also does not help you out, then you are only left with one more hack, i.e. factory default reset. In simple words, it means that you need to restore your WN200RPT wireless range extender to its default factory settings.
- Perform Factory Default Reset
The following steps will teach you how to perform Netgear extender factory reset:
- Check out every corner of your WN200RPT extender.
- Whenever you find the Reset button, press it.
- Hold on for some time.
As soon as the reset process finishes, set up your device right from scratch by accessing the Netgear extender login portal. You can also use the Nighthawk application in order to execute the same process.
Wrapping Up
Troubleshooting the Netgear WN200RPT extender red light issue is not such a big deal. However, a number of users experience issues while trying to resolve it. Considering you are amongst them, we hope that you were able to rectify it after going through the hacks given above. If you did, it is recommended that you share your feedback with your fellow readers via the comment section.